Chapter 6: Replication
Replication Send
Quantum DXi6900 User’s Guide 140
Queued The synchronization job is queued and will continue when the system is ready.
Success The synchronization job was completed successfully.
Recovering The recover operation is in process.
Replicating The replication operation is in process.
Failed The synchronization job was not completed.
Enabling Replication For a Share or Partition
Enable replication for a NAS share or VTL partition to allow the data on the share or partition to be replicated
to other DXi systems (the targets). Disable replication if you do not want to replicate the share or partition to
other DXi systems.
Note:To be eligible for replication, a share or partition must have data deduplication enabled at the
time it is created.
To enable or disable replication for a share or partition:
1. Select the share or partition and click Configure.
The ShareorPartitionConfigure window displays (see Figure 85 below).
Figure85:Share or Partition Configure Window
2. Select the EnableReplication check box to enable replication for the share or partition.
3. Or clear the EnableReplication check box to disable replication for the share or partition. Any jobs
from that share or partition that are in progress or queued will transition to failure. Also, all replication job
history for that combination of target and share or partition will be removed.
4. Select the check box for each replication target you want to replicate the share or partition to. (You must
select at least one target.) When the share or partition is replicated, its data will be sent to all selected
targets.
5. Click Apply.
To Next Page
Loading...
