Chapter 9: Configuration
VTL Configuration
Quantum DXi6900 User’s Guide 241
Figure151:Edit Remote Host Mapping Page
2. (Optional) Select the UseCCL check box to use the Command and Control LUN.
Note:The CCL (Command and Control LUN) is not used in most environments. This option is
recommended for host access groups that contain an HP-UX host. It can also be used if hosts that
are not assigned to any host access group exist in the SAN. The CCL is accessible to hosts only
through LUN 0.
Caution:If you are not sure if you should use CCL, contact Quantum Customer Support before
you enable this option.
3. Select the check boxes for the media changer and tape drives to add to the host access group.
The LUN assignment displays next to the device.
4. Click Apply.
DeletingaRemoteHostAccessGroup
Delete a host access group if it is no longer needed.
To delete a host access group:
To Next Page
Loading...
