Quantum DXi6900

Chapter 9: Configuration
VTL Configuration
Quantum DXi6900 User’s Guide 242
1. Select the group and click Delete.
Note:You can select multiple groups to delete at once.
2. Click Yes to confirm the deletion.
Remote Hosts
Use the RemoteHosts page to discover and add Fibre Channel hosts to the available host list for the
DXi6900.
Note:You must configure a host before you can assign it to a new host access group (see Adding a
Remote Host Access Group on page 239).
Caution:If you are connecting the DXi6900 directly to a host without using a Fibre Channel switch,
you must know the WWPN connecting to each DXi6900 port. If you do not specify this information, the
virtual medium changer and tape drives will not display on the device manager.
To access the RemoteHosts page, on the RemoteHostAccess page, click the RemoteHosts tab (see
Figure 152 below and Figure 153 below).
Figure152:Remote Hosts Page
Figure153:DXi6900 G2 / DXi6900-S Remote Hosts Page
To add a host:
1. Click DiscoverRemoteHosts to list all hosts that are known to the DXi6900.
A host is made known to the DXi6900 if you enter the host ID on this page, or if the host logs on to one
or more Fibre Channel target ports.