Quantum DXi6900

Chapter 9: Configuration
VTL Configuration
Quantum DXi6900 User’s Guide 243
If you do not see the world wide name (WWN) of the host, make sure the host is connected to a Fibre
Channel port on the DXi6900 and click DiscoverHosts again.
The BackpanelLocations section displays a graphical representation of the Fibre Channel and
Ethernet ports as they appear on the rear of the system.
Note:A mapped (green) status indicates the host is currently logged on to one or more Fibre
Channel target ports.
2. Enter information about the host:
RemoteHostWWPN Enter the World Wide Port Name (WWPN) of the host. (This value is entered
automatically by the system.)
Alias (Optional) Enter a descriptive alias for the host.
3. Click Apply.
Note:To delete a host that is no longer needed, click Delete next to the host. You cannot delete a host
of it is currently assigned to a host access group
Targets
Use the Targets page to view the current target (Fibre Channel) configuration.
To access the Targets page, on the HostAccess page, click the Targets tab (see Figure 154 below and
Figure 155 on the next page).
Figure154:DXi6900 G1 Targets Page