Quantum DXi6900

Chapter 9: Configuration
Replication Configuration
Quantum DXi6900 User’s Guide 269
Figure167:Replication Configuration Page
Tasks
Use the ReplicationConfiguration page to perform the following tasks:
l View information about configured replication target systems (see Target DXis List below).
l Add, edit, or delete a replication target (see Adding a Replication Target on the next page,Editing a
Replication Target on page 272, or Deleting a Replication Target on page 273).
l Pause or resume replication to a target (see Pausing or Resuming Replication to a Target on page
273).
l Configure a constant replication throttle (see Enabling System Throttling on page 274).
l View information about allowed replication source systems (see Source DXis List on page 275).
l Add or delete an allowed replication source (see Adding a Replication Source on page 275 or
Deleting a Replication Source on page 276).
l Specify the maximum number of received snapshots to retain for each source (see Changing the
Maximum Number of Snapshots on page 276).
Target DXis List
The TargetDXis list displays the following information for each target DXi:
Target The IP address of the target system that the DXi6900 is configured to send data to.
Status The replication status of the DXi6900. For a detailed description of all possible
replication statuses, see Replication Overview on page 124.
SourceIP The IP address that is used to uniquely identify the source DXi to the target.