Quantum DXi6900

Chapter 9: Configuration
Notifications
Quantum DXi6900 User’s Guide 302
agent is accessible from any IP address.
l When entering IP addresses, never use an address that is in a reserved IP address range. To
see a list of reserved IP address ranges, click the quick tip icon [?] located near the IP address
field.
4. In the AccessType drop-down box, select the access type for the community:
Get Allows SNMP get operations.
Get/Set Allows both SNMP get and put operations.
5. Select the Communitystatus check box to enable the community.
Or clear the Communitystatus check box to disable the community.
6. Click Apply.
EditingaCommunity
Edit an SNMP community to change the IP address or access type for the community. You can also enable
or disable the community.
To edit a community:
1. Click Edit.
The EditSNMPCommunity page displays (see Figure 188 below).
Figure188:Edit SNMP Community Page
2. (Optional) In the Name box, select a different community to edit.
3. Enter a valid IPAddressandNetworkMask pair.
A pair is valid if performing a logical bitwise AND operation on the IP address and the network mask
results in the IP address. See the table below for examples: