Quantum DXi6900

Chapter 9: Configuration
System
Quantum DXi6900 User’s Guide 309
Figure192:Network Page: Interface Details
1. If necessary, click the Show link to show the interface details table.
2. For each device, select the MTU (Maximum Transmission Unit) frame size in the JumboFrameMTU
Size drop-down box.
1500MTU (Default) The standard (STD) MTU frame size of 1,500 bytes is used.
9000MTU The jumbo MTU frame size of 9,000 bytes is used. (For best performance, make sure
the entire network path to the DXi is configured to use 9000 MTU.)
3. Click Update to save the changes you made to the InterfaceDetails table. (Clicking Update does not
yet apply the new network settings to the DXi6900.)
4. Click Undo to revert to all current Interface Details changes to the last update.
ConfiguringInterfaceIPAddresses
Under IPAddressConfiguration>IPAddressTable, configure one or more network interfaces for
each port or device (physical Ethernet port or bonded device) (see Figure 193 below):
Figure193:Network Page: IP Address Table
1. Click AddIP to add a network interface to a device.
Or select an interface to edit the IP address, netmask, gateway and traffic type. (To select an interface,
click the radio button next to the interface index name, for example, bond0:2.)