Quantum DXi6900

Chapter 9: Configuration
System
Quantum DXi6900 User’s Guide 315
DestNetmask Use 255.255.255.255.
DestGateway Use the replication IP address of the source DXi (192.168.10.100).
Example3:SegmentsontheSameSubnetandTargetonaDifferentSubnet
In the example below (see on page 305), the DXi has two segmented interfaces, one for data and
management traffic, and one for replication traffic:
l The source DXi management/data IP address and the source DXi replication IP address are on the same
subnet (192.168.10.x). The target DXi IP address is on a different subnet (192.168.20.x)
l To make sure the replication segment is used when communicating with the target DXi, you must add a
network route in the RoutingDetails section on the source DXi.
In this example, you would specify the following routing details for the replication interface on the source
DXi:
Destination Use the subnet of the target DXi (192.168.20.0).
DestNetmask Use 255.255.255.0.
DestGateway Use the IP address of the gateway (192.168.10.1).
l In addition, to enable communication with the target DXi by means of the gateway, you must add a
second host route in the RoutingDetails section on the source DXi.
In this example, you would specify a second set of routing details for the replication interface on the source
DXi:
Destination Use the IP address of the gateway (192.168.10.1).
DestNetmask Use 255.255.255.255.
DestGateway Use the replication IP address of the source DXi (192.168.10.100).