Quantum DXi6900

Chapter 9: Configuration
System
Quantum DXi6900 User’s Guide 321
l Enable or disable SSH access for the service account (Enabling SSH/CLI Service Account on page
326)
ChangingGUIAdministratorPassword
Use the GUI password when logging onto the remote management console as an administrator (see
Accessing Remote Management on page 65).
1. Under GUIAdministrator enter the following information:
OldPassword Enter the old password.
NewPassword Enter the new password.
ConfirmNewPassword Enter the new password again to confirm it.
AdditionalInformation
l Passwords can be up to 32 characters. Alphanumeric characters and special characters are
allowed.
l Loss of this password will require Quantum service support.
2. Click Apply.
EnablingGUIMonitorAccount
Use the GUI password when logging onto the remote management console as a monitor (see Accessing
Remote Management on page 65).
1. Under GUIMonitor do one of the following steps:
l Select the Enableaccount check box to enable the GUI monitor account.
l Clear the Enableaccount check box to disable the GUI monitor account.
2. Enter the following information:
NewPassword Enter the new password.
ConfirmNewPassword Enter the new password again to confirm it.
AdditionalInformation
Passwords can be up to 32 characters. Alphanumeric characters and special characters are