Quantum DXi6900

Chapter 9: Configuration
System
Quantum DXi6900 User’s Guide 326
AdditionalInformation
l Passwords can be up to 32 characters. Alphanumeric characters and special characters are
allowed.
l For accounts enabled with both SSH and password authentication, the DXi system will first
attempt SSH authentication . If there are no keys defined or no client key matches, the DXi
system will fall back to password authentication.
4. Click Apply.
EnablingGUIServiceAccount
Use the GUI password when logging onto the remote management console as a service account (see
Accessing Remote Management on page 65).
To enable or disable the GUI service account:
1. Under GUIService do one of the following steps:
l Select the Enableaccount check box to enable the GUI service account.
l Clear the Enableaccount check box to disable the GUI service account.
2. Enter the following information:
NewPassword Enter the new password.
ConfirmNewPassword Enter the new password again to confirm it.
AdditionalInformation
l Passwords can be up to 32 characters. Alphanumeric characters and special characters are
allowed.
3. Click Apply.
EnablingSSH/CLIServiceAccount
The SSH service account provides SSH remote access to the DXi6900 system.
1. Under SSHService, do one of the following steps:
l Select the Enableaccount check box to enable SSH service account
l Clear the Enableaccount check box to disable the SSH service account
2. The SSH service account may be configured with Secure Shell (SSH) key-based authentication.
AddanSSHPublicKey