Quantum DXi6900

Chapter 10: Utilities
Diagnostics
Quantum DXi6900 User’s Guide 360
Figure231:Status Page
The Status page displays the following information about the most recently run test for each healthcheck:
HealthcheckName The name of the healthcheck.
State The state of the healthcheck (enabled or disabled).
Started The time the healthcheck started
Finished The time the healthcheck ended.
Status The status of the healthcheck (Success or Failed).
Note:If running a healthcheck results in the Contact Support status, contact
Quantum Customer Support for further assistance.
To enable or disable a healthcheck:
1. Select the healthcheck and click Edit.
The EditHealthcheck page displays (see Figure 232 below).
Figure232:Edit Healthcheck Page
2. Select the check box to enable the healthcheck.
Or clear the check box to disable the healthcheck.
3. Click Apply.
Note:When healthchecks are run (manually or scheduled), only enabled healthchecks are run.