Quantum QX Series User Manual

Chapter 5: Troubleshooting
Isolate Replication Faults
QX and QXS Setup Guide 152
Answer Possiblereasons Actions
Yes System
functioning
properly.
No action required.
No The replication
feature is not
licensed on each
RAID chassis
used for
replication.
See actions described in Can you successfully use the replication feature?
No Nonexistent
replication set.
l Determine existence of primary or secondary volumes.
l If a replication set has not been successfully created, use the Replication
Setup Wizard to create one.
l Review event logs (in the Configuration View panel, right-click the system,
and select View>EventLog) for indicators of a specific fault in a
replication data path component. Follow any Recommended Actions.
No Network error
occurred during in-
progress
replication.
l Review event logs for indicators of a specific fault in a replication data path
component. Follow any Recommended Actions.
l In the Configuration View panel, right-click the secondary volume, and
select View > Overview to display the Replication Volume Overview table:
o
Check for replication interruption (suspended) status.
o
Check for inconsistent status.
o
Check for offline status.
l Replications that enter the suspended state can be resumed manually.
No Communication
link is down.
See actions described in Can you view information about remote links?
Table32:Replicate a Volume
Can you view a replication image?
Answer Possiblereasons Actions
Yes System
functioning
properly.
No action required.
Table33:Replication Image

Quantum QX Series Specifications

General

Brand	Quantum
Model	QX Series
Category	Storage
Language	English