Chapter 2: Installing the Chassis
Populate QXS 48-Drive Drawers
QX and QXS Setup Guide 58
l Each drive is mated to a connector on the drawer PCBA.
l In the absence of quantity-four drives, the chassis uses an AMS insert within drive bays to manage air
flow within the chassis, to help maintain optimal operating temperature.
Figure64:Aligning/Installing an AMS or Drive into Drawer
1. AMS
2. Disk
Each drawer has four drive bays. Each drive bay must be populated with either four (4 each) AMS inserts or
a full complement of four drives.
Installing an AMS Into a drawer
Refer to Figure 65 on the next page when orienting the AMS for insertion into the target drawer.
l If you are installing into the left drawer or middle drawer, refer to the illustration on the left when
performing this step-procedure.
To Next Page
Loading...
