Quectel LTE Series - At+Qgpscfg=Nmeasrc Enable;Disable Acquisition of NMEA Sentences Via AT+QGPSGNMEA

LTE Module Series
EP06&EG06&EM06 GNSS AT Commands Manual
EP06&EG06&EM06_GNSS_AT_Commands_Manual 9 / 29
Parameter
2.1.2. AT+QGPSCFG="nmeasrc" Enable/Disable Acquisition of NMEA Sentences via
AT+QGPSGNMEA
The command enables/disables acquisition of NMEA sentences via AT+QGPSGNMEA.
Parameter
If there is any error related to ME functionality:
+CME ERROR: <errcode>
Reference
<outport> Configure the output port of NMEA sentences, and the configuration parameter
will be automatically saved to NVRAM.
“none” Close NMEA sentence output
“usbnmea” Output via USB NMEA port
“uartdebug” Output via debug UART port
<errcode> Integer type. The error code of the operation. If it is not 0, it is the type of error.
Please refer to Chapter 4 for details.
AT+QGPSCFG="nmeasrc" Enable/Disable Acquisition of NMEA Sentences via
AT+QGPSGNMEA
Write Command
AT+QGPSCFG="nmeasrc"[,<nmeasrc
>]
Response
When there are two parameters:
OK
When the second parameter is omitted, query the current
setting:
+QGPSCFG: "nmeasrc",<nmeasrc>
OK
If there is any error related to ME functionality:
+CME ERROR: <errcode>
Reference
<nmeasrc> After being enabled, original NMEA sentences can be acquired via
AT+QGPSGNMEA, and the configuration parameter will be automatically
saved to NVRAM. Meanwhile, sentences are outputted via the same NMEA