Quectel LTE Series - At+Qgpscfg=Gnssconfig Configure Supported GNSS Constellations; At+Qgpscfg=Autogps Enable;Disable GNSS to Run Automatically

LTE Module Series
EP06&EG06&EM06 GNSS AT Commands Manual
EP06&EG06&EM06_GNSS_AT_Commands_Manual 14 / 29
2.1.8. AT+QGPSCFG="gnssconfig" Configure Supported GNSS Constellations
Parameter
2.1.9. AT+QGPSCFG="autogps" Enable/Disable GNSS to Run Automatically
AT+QGPSCFG="gnssconfig" Configure Supported GNSS Constellations
Write Command
AT+QGPSCFG="gnssconfig"[,<gnssc
onfig>]
Response
When there are two parameters:
OK
When the second parameter is omitted, query the current
setting:
+QGPSCFG: "gnssconfig",<gnssconfig>
OK
If there is any error related to ME functionality:
+CME ERROR: <errcode>
Reference
<gnssconfig> Supported GNSS constellations
GPS is always ON
0 GLONASS OFF/BeiDou OFF/Galileo OFF
1 GLONASS ON/BeiDou ON/Galileo ON
2 GLONASS ON/BeiDou ON/Galileo OFF
3 GLONASS ON/BeiDou OFF/Galileo ON
4 GLONASS ON/BeiDou OFF/Galileo OFF
5 GLONASS OFF/BeiDou ON/Galileo ON
6 GLONASS OFF/BeiDou OFF/Galileo ON
<errcode> Integer type. The error code of the operation. If it is not 0, it is the type of error.
Please refer to Chapter 4 for details.
AT+QGPSCFG="autogps" Enable/Disable GNSS to Run Automatically
Write Command
AT+QGPSCFG="autogps"[,<autogps
>]
Response
When there are two parameters:
OK
When the second parameter is omitted, query the current
setting: