Quectel LTE Series - Description of GNSS AT Commands; AT+QGPSCFG GNSS Configurations

LTE Module Series
EP06&EG06&EM06 GNSS AT Commands Manual
EP06&EG06&EM06_GNSS_AT_Commands_Manual 8 / 29
2 Description of GNSS AT Commands
2.1. AT+QGPSCFG GNSS Configurations
The command is used to query and configure various GNSS settings, including NMEA sentences output
port, output type of NMEA sentences, and more.
2.1.1. AT+QGPSCFG="outport" Configure NMEA Sentences Output Port
AT+QGPSCFG GNSS Configurations
Test Command
AT+QGPSCFG=?
Response
+QGPSCFG: "outport",("none","usbnmea","uartdebug")
+QGPSCFG: "nmeasrc",(0,1)
+QGPSCFG: "gpsnmeatype",(0-31)
+QGPSCFG: "glonassnmeatype",(0-7)
+QGPSCFG: "galileonmeatype",(0,1)
+QGPSCFG: "beidounmeatype",(0-3)
+QGPSCFG: "gsvextnmeatype",(0,1)
+QGPSCFG: "gnssconfig",(0-6)
+QGPSCFG: "autogps",(0,1)
OK
Reference
AT+QGPSCFG="outport" Configure NMEA Sentences Output Port
Write Command
AT+QGPSCFG="outport"[,<outport>]
Response
When there are two parameters:
OK
When the second parameter is omitted, query the current
setting:
+QGPSCFG: "outport",<outport>
OK