LTE Module Series
EP06&EG06&EM06 GNSS AT Commands Manual
EP06&EG06&EM06_GNSS_AT_Commands_Manual 17 / 29
Parameter
2.4. AT+QGPSEND Turn off GNSS
When GNSS is turned on and <fixcount> is 0, GNSS fixes position continuously. In this case, GNSS can
be turned off compulsorily via AT+QGPSEND. When <fixcount> is non-zero, GNSS will be turned off
automatically if the parameter reaches the specified value, and thus the command can be ignored.
<gnssstate> GNSS state
0 GNSS OFF
1 GNSS ON
<gnssmode> GNSS working mode
1 Stand-alone
2 MS-based
3 MS-assisted
4 Speed-optimal
<fixmaxtime> The maximum positioning time (unit: s), which indicates the response time of
GNSS receiver while measuring the GNSS pseudo range and the upper time limit
of GNSS satellite searching. It also includes the time for demodulating the
ephemeris data and calculating the position.
1-30-255 Maximum positioning time
<fixmaxdist> Accuracy threshold of positioning. Unit: m.
1-50-1000
<fixcount> Number of attempts for positioning
0–1000 0 indicates continuous positioning. Non-zero values indicate the
actual number of attempts for positioning.
<fixrate> The interval time between the first and second time positioning. Unit: s.
1–65535
<errcode> Integer type. The error code of the operation. If it is not 0, it is the type of error.
Please refer to Chapter 4 for details.
To Next Page
Loading...
