Quest Engineering X5 User Manual

12
Product Care Tips
 Do not wrap the coil cable too tightly around the shaft as adjusting the coil can pull on the cable damaging the wire or the
connection
 Do not store the device where prolonged exposure to extreme temperatures can occur to avoid damaging the X5. Leaving it in a
car during the summer should be avoided for this reason.
 Never use a hard or sharp object to operate the touch pads or damage may result.
 Avoid chemical cleaners, solvents, and insect repellents that can damage plastic components and finishes.
 Secure the weather cap tightly to prevent damage to the USB port or allow moisture / sand to enter it.
 Even small amounts of moisture can cause corrosion of the electrical contacts when connected to a charger – ensure it is dry!
 If you are storing the detector for an extended period of time, recharge the internal battery every 4 – 6 months
 The search coil is waterproof and can be fully submerged; however, the control housing is not waterproof (it is water resistant)
 The X5 can withstand heavy rain; however, submerging the control housing in water can result in damage to the electronics
CLEAN YOUR DETECTOR WHEN YOU GET HOME
 Turn off the detector before you start to wipe it down.
 Wipe the device using a damp cloth using nothing more than a mild detergent solution.
 Wipe it dry with soft, clean, lint-free cloth. Allow the device to dry completely before reassembling it.
 Gently wipe the screen with the cloth.

Quest Engineering X5 Specifications

General

Brand	Quest Engineering
Model	X5
Category	Metal Detector
Language	English