5
Charging the Quest X5’s Battery
The Quest X5 features an internal Li-Po rechargeable battery which eliminates the cost of buying
batteries for your detector.
To initially charge the battery or recharge it when you are heading to the hunt site or coming in from
the field, pry off the moisture / dust cover on the back of the control housing. Connect one end of
the micro USB charging cable to the lower plug in the control housing and the other to a wall or car
charger that accepts the USB connector.
NOTE: Depending on the wall / car charger used, it should take around 4 hours to fully charge the
X5.
Quick Start Operation
Before you head out looking for lost items, spend a few minutes getting familiar with the X5’s controls and the response it produces
to known targets. A little time invested after you unpack the detector will pay off in the field as you will know how to adjust it and
what the type of targets you are looking for sound like.
Place the X5 on a table with the coil away from any metal
Turn it on by pressing the POWER touchpad (see Page 3)
To Next Page
Loading...
Need help?
General
