Q150T Sample Preparation System
10473 - Issue 5 20 Q150T - Instruction Manual
3.3 System Settings
The operation of the Q150T is controlled by its profile parameters. However, there are
several system parameters, which can be changed without altering the profile. A system-
set parameter overrides the corresponding setting specified in the active profile. You can
make the new setting apply just to runs using the active profile or to all runs, irrespective
of the choice of profile.
To change a system parameter:
1. Open Profile Editor: from the standby screen, tap on the Edit Profile button or
choose Edit | Profiles from the menu bar.
2. Tap on the + sign to the left of the currently active profile (see Figure 3-5 - left).
Figure 3-5. Listing system properties for a profile
3. Tap on System. System Property Editor is displayed (see Figure 3-5 - right).
4. You are prompted to confirm whether the changes are to be applied to runs using
this profile only or to all runs. Tap on the Yes button to apply changes to the active
profile only, or No to apply the change to all runs.
Figure 3-6. Changing the Stage Rotate system property
5. Tap on the value of the system property you want to change (in this case, Stage
Rotate). Amend the setting as required and confirm the change by tapping on the
OK button. Tap on the Cancel button to cancel any change (see Figure 3-6).
6. Altered system parameters are shown with blue text.
7. Tap on the OK button to exit the System Property Editor.
To Next Page
Loading...
Need help?
General
