Rabe Mega Seed - Table of Contents

2
Subject to technical change without notice
09.2003
3
Subject to technical change without notice
09.2003 09.2003
Table of contents
1. Introduction
1.1 Brief description.............................................................................................. 4
1.2 Technical data................................................................................................. 4
2 Commissioning
2.1 Technical requirements..................................................................................... 5
2.2 Switching on the controller................................................................................. 5
2.3 Standard values (maker’s default settings) and custom settings............................. 6
2.4 reset.............................................................................................................. 7
3 Working with the control program
3.1 Main screen – ”Main” screen <M>................................................................ 8
3.1.1 Softkey functions....................................................................................... 10
3.2 Setting operating parameters....................................................................... 11
3.2.1 Accessing the parameter menus <P>........................................................ 11
3.2.2 Seed type selection....................................................................................... 12
3.2.3 Calibration................................................................................................... 12
3.2.4 Tramline settings.......................................................................................... 15
3.2.5 Warning parameters..................................................................................... 15
3.2.6 Job management.......................................................................................... 15
3.3 Alarm screen................................................................................................ 16
3.4 Function screen ”RATE”................................................................................ 17
3.4.1 Display seed rate.......................................................................................... 17
3.4.2 Changing the rate on the move....................................................................... 17
3.5 INFO screen <I>.......................................................................................... 17
3.5.1 Display values.............................................................................................. 17
3.5.2 Hectare counter (total and partial area)........................................................... 17
3.5.3 GRAND........................................................................................................ 18
4 Accessing the parameter screens <P>
4.1 Bediener-Einstellungen (Operator-Setup).................................................... 19
4.1 Operator setup............................................................................................. 19
4.1.2 Speed sensor factor....................................................................................... 19
4.1.3 Customise.................................................................................................... 20
4.1.4 Seed type selection........................................................................................ 22
4.1.5 Date/Time................................................................................................... 26
4.1.6 Info number................................................................................................. 26
4.1.7 Select language............................................................................................ 26
4.2 Drill conguration........................................................................................
27
4.2.1 PRO series...................................................................................................
27
4.2.2 Module types............................................................................................... 27
4.2.3 Module cong (set working width)................................................................. 27
4.3 Factory setup.............................................................................................. 28
4.3.1Cong Type 4................................................................................................ 28
4.3.2 Establish a connection................................................................................... 28
4.3.3 Diagnosis.................................................................................................... 28