On a Desk Top
1. Connect the corded handset
cord to left side of the base
and to the corded handset.
Route the curl cord inside the
molded wiring channel as
shown.
2. Plug one end of the supplied long modular cord into the
PHONE jack on the back of the base.
3. Insert the supplied AC adapter’s barrel plug into the
DC IN 9V
jack on the back of the base.
4. Route the adapter cord and
modular cord through the
slot as shown.
5. Plug the other end of the
modular cord into a modular
phone line jack.
6. Plug the adapter into a
standard AC outlet.
CAUTION: You must use a Class 2 power source that
supplies 9V DC and delivers at least 500 mA (for the
base)/210 mA (for the charger). Its center tip must
be set to positive and its plug must t the phone’s
DC IN 9V jack. The supplied adapter meets these
specications. Using an adapter that does not meet
these specications could damage the phone or the
adapter.
To Next Page
Loading...
