Additional Information
Installing the Belt Clip
To attach the belt clip
Insert the belt clip into the holes
on each side of the handset.
Press down until it clicks.
To remove the belt clip
Pull both sides of the belt clip to release the tabs from the holes.
Installing the Optional Headset
You can connect an optional headset
with a
3
/
32
-inch (2.5-mm) plug. Contact
your local RadioShack store for a
suitable headset.
To connect the headset, open the rubber
cover on the side of the handset. Then
insert the headset’s plug into the jack.
disconnect it from the handset and close the rubber cover to
protect the jack.
If you place the handset on the charger to recharge
it while the headset is connected, be sure the
handset seats properly.
You can use a handset holder (available from your
local RadioShack store) to hang the handset on
your belt for greater convenience when using a
headset.
•
•
To Next Page
Loading...
