If you make a mistake while entering a name
Use
/TONE/ or #/ to move the cursor to the incorrect
character.
Press
DEL/CH to erase the wrong character. Then enter the
correct character. To delete all characters, press and hold
DEL/CH.
5. Press SELECT/INT’COM
number to be entered.
6. Use the keypad to enter the phone number; each number
the dialing sequence, press REDIAL/PAUSE to insert a two-
second pause between the numbers.
pause counts as a digit. The display shows a P for every
pause.
If the next character uses the same number key, you
must press #/ to move the cursor over. Otherwise
the next time you press the number key, it changes
the character that was previously set.
7. Press SELECT/INT’COM
8. After about two seconds, the speed dial entries will appear.
9. Press
MEM to exit memory setup mode. The phone returns to
standby.
To Next Page
Loading...
