OWNER’S MANUAL
8. Repeat steps 3 through 7 (starting on the previous page) two more times
to map the remaining volume control keys, substituting VOL ▼ and MUTE
as source and destination keys in steps 5 and 7.
9. Exit programming by pressing once. The display will return to the
last-selected device menu screen.
Upon completion of the above procedure, you can now use your RadioShack
4-in-One Remote to control the TV’s volume and mute in the DVD mode, as
well as in the TV mode.
RESTORING A SINGLE KEYMOVED KEY
1. Press and hold P until the bottom IR segment flashes twice. The program
keys will appear:
2. Press above OTHER once. The Other programming screen will appear:
3. Using the number keys, enter 9 9 4. The bottom IR segment will
flash twice.
4. Press the destination mode once where the keymoved key is stored.
Then press the destination key twice. Upon key restoration, the bottom
IR segment will flash twice as confirmation.The program keys will
appear again.
5. If desired, repeat steps 1 and 2 to restore another key.
6. Exit programming by pressing once. The display will return to the
last-selected device menu screen.
Using Keymover 19
To Next Page
Loading...
