4-IN-ONE REMOTE POWERED BY KAMELEON
INSTALLING BATTERIES (Continued)
ABOUT BATTERY LIFE
As with all battery-operated devices,battery life will vary depending on use,
including frequency and duration of key presses on the Kameleon screen.
Battery life may be extended by:
• Reducing the brightness level of the display screen (see Adjusting
Brightness on page 9).
• Disabling the Kameleon “tilt on”feature (see Setting The Tilt Switch on
page 23).
INSTALLING BATTERIES IN THE REMOTE
Your remote requires four AAA batteries (not supplied) for power.
1. Push the indent on the battery compartment cover (located on the back of
the remote) and lift off the cover.
2. Place the AAA batteries in the compartment as indicated by the polarity
symbols (+ and –) marked inside.
3. Align the cover with the compartment opening and replace it.
4. If batteries are inserted correctly, the display will turn on and show all keys
after any key is pressed.
NOTE: The batteries will need replacement if one of the following conditions occurs:
1. The top IR segment flashes five times after pressing a key.
2. The Tilt Switch (if enabled, see page 23) no longer activates the remote and only
pressing a key turns on the display.
4 Installing Batteries
To Next Page
Loading...
