78
Beyond the Basics
5. Press ENT for each entry. If you make a mistake,
press CLEAR and enter the correct size code.
The default setting of the bank is for Motorola Type
II. However, if you set Type I and you want to return
to Type II, enter 15 at Step 4.
To confi rm the input, repeat Steps 1-5 and press
ENT. Each time you press ENT, you confi rm the size
code. If you fi nd an error, press CLEAR and begin
again at Step 1.
6. Press SCAN to start scanning.
talk group IDs
There are 10 talk group ID banks and each ID bank has
5 sub-banks. Each sub-bank has 30 ID locations. You
can program up to 150 talk group IDs in each bank,
so you can program up to 1,500 talk group IDs in 10
banks. When the scanner stops on a transmission in
the Motorola, EDACS, or LTR mode, it checks to see
if the ID has been stored. In the closed mode, the
scanner only stops on the transmission and displays
its text tag if you have stored and not locked out the
ID. In the open mode, the scanner always stops on a
transmission, but it displays the ID’s text tag if you have
stored the ID.
storing talk group IDs
To store a talk group ID, press TRUNK when the scanner
stops on a voice channel transmission or when a talk
group ID is indicated in the manual mode. The bottom
line indicates where the ID was stored (as ID save X-
XX), then it changes to ID#XXXX.
To Next Page
Loading...
