79
Beyond the Basics
The fi rst X in ID save X-XX is the sub-bank number (0-4)
in the bank. XX is the number of IDs from (00-29) in
each sub-bank.
If the ID has already been stored when you press
TRUNK, ID was saved appears.
When you try to store more than 150 talk group
IDs in a bank, Memory Full! appears. Clear some
talk group IDs in order to store new ones (see
“Clearing Talk Group IDs”).
Follow these steps to manually store talk group IDs or
to edit a stored ID.
1. Press PROG.
2. Press TRUNK.
3. To select the bank where you want to store the ID,
repeatedly press FUNC then e or d until you reach
the desired bank.
4. Press MODE to select MOT, ED, or LTR.
5. Repeatedly press TRUNK to select the sub-bank.
6. Press e or d to select the location where you
desire to store the ID number.
7. Enter the talk group ID and press ENT. If necessary,
use the decimal point for a hyphen.
To Next Page
Loading...
