81
Beyond the Basics
talk group ID hold
You can set your scanner to follow a trunking signal
that you want to track during scanning. While the
scanner is stopped on a voice channel (VC appears),
hold down TRUNK until ID hold ON. appears.
When ID hold is activated and the scanner receives a
voice channel, the scan indication S at the fi rst digit in
the top line changes to H.
To release ID hold, press SCAN or TRUNK.
turning an ID sub-bank on or off
Follow these steps to turn the ID sub-bank on or off
during the program mode:
1. Press TRUNK repeatedly to select the desired sub-
bank.
2. Press FUNC then 1 to turn the sub-bank on if it is off
or off if it is on.
Follow these steps to turn the ID sub-bank on or off
during the scan mode:
1. Press FUNC while the scanner is stopped on a voice
channel transmission.
2. Press TRUNK. The display indicates which sub-bank
is turned on or off, and the active sub-bank number
fl ashes.
To Next Page
Loading...
