83
Beyond the Basics
1. Press FUNC then ./DELAY while you are programming
the trunked ID. Use Up/Down keys to set ID Delay. ENTER
key saves. 2.0 seconds appears.
2. Press e or d to select None, 0.5, 1.0, 1.5, 2.0, 2.5,
3.0, 3.5, or 4.0 seconds.
3. Press ENT.
When activated, ID delay watches the control
channel command for the delay time when the
signal disappears from the voice channel.
reviewing locked-out talk group IDs
You cannot clear all lockouts from a talk group at the
same time.
1. Press PROG then TRUNK.
2. Press FUNC. Then L/OUT. The locked out ID appears.
If the ID memory bank has no locked-out ID, you
hear the low beep tone.
clearing talk group IDs
1. Press PROG then TRUNK.
2. Press FUNC, e or d to select ID memory.
3. Press FUNC then CLEAR.
clearing all talk group IDs in a single bank
You can clear all talk group IDs within a bank. This lets
you quickly delete all talk group IDs from a bank if you
want to use the bank to store different data (such as a
new set of talk group IDs).
To Next Page
Loading...
