Operation
28
quency (including the decimal
point) you want to store.
If you make a mistake, press
CL
to delete a single digit or
press and hold
CL
about 2
seconds to delete all digits.
4. Press
ENTER
to store the
frequency into the channel.
±
5. If necessary, press
MODE
to
change the receiving mode.
6. If desired, program a text tag
for the channel (see
“Assigning a Text Tag to a
Channel” on Page 29).
7. The next channel in sequence
is ready for programming.
Press
PGM
and then repeat
steps 3 through 6.
5614+0)"6470-+0)"
(4'37'0%+'5"+061"
%*#00'.5
1. Press
PGM
and
FUNC
then
8
88
8
or
9
99
9
to select the desired
bank to program.
2. Press
TRUNK
to enter into
trunking mode.
3. Repeatedly press
MODE
to
select
CEJ
CEJCEJ
CEJ
(Motorola) or
;:
;:;:
;:
(EDACS).
4. Press
PGM
and select the
channel number using
8
88
8
or
9
99
9
.
5. Enter the UHF trunking
frequency and press
ENTER
.
6. Repeat Steps 4 and 5 to enter
the other trunking group
±
"016'"
±
"
• If you made a
mistake in Step 3,
?dlWb_Zý<h[g
?dlWb_Zý<h[g?dlWb_Zý<h[g
?dlWb_Zý<h[g
briefly
appears and the
scanner beeps
when you press
ENTER
. Start
again from Step 3.
• Your scanner
automatically
rounds the
entered frequency
to the nearest
valid frequency.
For example, if
you enter a
frequency of
151.553, your
scanner accepts it
as
'+'$++&
'+'$++&'+'$++&
'+'$++&
.
• After a
transmission, to
have the scanner
pause for 2
seconds on this
channel before
proceeding to the
next active
transmission,
press
.
/
DELAY
to
turn the delay
function on. See
“Using the Delay
Function” on
Page 45. The
scanner stores
this setting in the
20-525NEW.fm Page 28 Monday, July 1, 2002 2:58 PM
To Next Page
Loading...
