64
Beyond the Basics
cloning the programmed data
You can transfer the programmed data to and from another
PRO-97 scanner using an optional connecting cable with
1/8-inch (3.5 mm) phone plugs on both ends (not supplied,
available at your local RadioShack store).
“CLONE MODE” Incorrect Model appears if the scanner
receives data from another scanner other than a PRO-97.
Follow these steps to clone the data.
1. Turn on both scanners.
2. Connect the connecting cable to each scanner’s PC/IF
jack. **CLONE MODE** Press UP to send Remove cable to exit.
appears.
3. Press
e. Confi rm to send data? 1 -> YES Press other key for NO.
appears.
4. Press 1 to send the data to the other unit or press any
other key to cancel the operation.
The scanner sends the data. To exit the clone mode, remove
the cable.
To Next Page
Loading...
