76
Beyond the Basics
talk group ID hold
You can set your scanner to follow a trunking signal that you
want to track during scanning. While the scanner is stopped
on a voice channel (VC appears), hold down TRUNK until ID
hold ON. appears.
When ID hold is activated and the scanner receives a voice
channel, the scan indication S at the fi rst digit in the top line
changes to H.
To release ID hold, press SCAN or TRUNK.
turning an ID sub-bank on or off
Follow these steps to turn the ID sub-bank on or off during
the program mode:
1. Press TRUNK repeatedly to select the desired sub-bank.
2. Press FUNC then 1 to turn the sub-bank on if it is off or off if
it is on.
Follow these steps to turn the ID sub-bank on or off during
the scan mode:
1. Press FUNC while the scanner is stopped on a voice
channel transmission.
2. Press TRUNK. The display indicates which sub-bank is
turned on or off, and the active sub-bank number fl ashes.
3. Press FUNC and the number of the sub-bank you desire to
turn on or off. For example to turn sub-bank 4 on or off,
press FUNC. Then press 4.
To Next Page
Loading...
