The message
Replace system diskette with destination diskette. Ready
(Y)
appears. Remove your Systems Diskette from Drive 0 and
insert the destination diskette. Type Y
(ENTER);
the backup
continues.
When the backup
is
complete, the message
Mount system disk. Ready
(Y)
is
displayed Remove the destination diskette from Drive
(jj
and insert your Systems diskette. Type Y
(ENTER),
the Ready
prompt
is
displayed
•
Backing Up TRSDOS·II Data Diskettes Using a
Hard Disk System
You
need at least two floppy diskette drives for this method.
1.
Power up under hard disk control
2.
Insert the TRSDOS-II source data diskette into Drive
0,
Insert
the destination diskette into Drive
2.
Use a double-sided
diskette for maximum storage space.
3.
Enter the date and time.
4.
When TRSDOS-II Ready
is
displayed, type
BACKUP
0
TO
2
IENTER)
•
"Backup Successfully Completed"
is
displayed when the
backup
is
finished.
TRSDOS Backup
The
TRSDOS BACKUP utility makes a copy of a diskette.
If
you
have enough floppy diskette drives, you can use this utility to
copy
any TRSDOS system or data diskette.
When backing up any TRSDOS diskette, keep TRSDOS 2.0b
In
Drive
0.
Put the diskette you wish
to
back
up ("source" diskette)
in
another drive.
Backing Up TRSDOS System Diskettes
To
back up any diskette that contains TRSDOS, follow the steps
given under "Backing Up Your Thinline TRSDOS
2.0b Diskette,"
in
Chapter 7 Substitute the TRSDOS system diskette for the TRSDOS
2.0b System Diskette
Model16B and Enhanced Model
12
Users:
To
back
up
a
TRSDOS system diskette, you must first patch
it
for use on Thinline
drives. (See "Loading a TRSDOS Program"
in
Chapter 6 )
•
48
To Next Page
Loading...
Need help?
General
