BACKUP displays the following message when the backup
is
complete
Backup Successfully Complete
Drive 2 Disk
10
is
TRSDDS-II Ready
If
your screen displays a message that the backup aborted, repeat
Steps 5 through
7,
using a different destination diskette
Backing
Up
Your Thinline TRSDOS 2.0b Diskette
To
back up your Thinline TRSDOS 2 0b Diskette, you must use the
TRSDOS FORMAT and BACKUP utilities. The FORMAT utility
organizes the diskette to which the information
is
to
be copied
("destination diskette) BACKUP then copies all the information
from the "source' diskette to the destination,
To
format a blank diskette and then back up your Thinline TRSDOS
2,0b Diskette, follow these steps
1 Prepare a destination diskette by covering the write-protect
notch of a blank diskette with a write-enable tab
2 Power up or reset the computer. Press
(RPT)
(BREAK)
to
operate
under floppy diskette control
3.
Insert the TRSDOS 2 0b Diskette ("source" diskette) into Drive
0.
4.
When prompted, enter the date
in
mm/dd/yyyy format (for
example: 03/19/1983 for March
19,
1983). Press
(ENTER)
when
prompted for the time TRSDOS READY
IS
displayed
Customers with two or more floppy drives:
5.
Insert the destination diskette into Drive
2.
At TRSDOS
READY, type
FORMAT 2
(ENTER)
6.
The folloWing prompt
is
displayed
on
the screen
Mount Diskette for Formatting
on
Drive 2
Continue? (Y/O)
Since you already have mounted your diskette
on
Drive
2,
type Y
(ENTER)
to continue,
1.
If
you are formatting over a used diskette, the following
prompt might appear:
Diskette CONTAINS DATA; Format OVER it? (Y/O)
If
you do not need the data
on
the diskette, type Y
(ENTER),
If
you might need the data, type Q
(ENTER).
28
•
•
•
To Next Page
Loading...
Need help?
General
