•
•
•
SECTION
11/
HARD DISK CONTROL
To
use your hard disk, you must first prepare it. How you do this
depends
on
what programs you will run under hard disk control.
• TRS-XENIX programs - Programs that run under the
TRS-XENIX, multi-user operating system (Multi-user means that
more than one person can use the operating system at the
same time.)
• TRSDOS-II or TRSDOS programs - Programs that run under
the TRSDOS-II or TRSDOS, single-user operating system.
You
cannot
run
both TRS-XENIX and TRSDOS-lliTRSDOS
programs under the same operatinq system You must select one
operating system or the other
I
Customers with
TRS~XENIX
programs: Prepare your primary
hard disk for TRS-XENIX programs (Chapter
4)
Customers with TRSDOS-IIITRSDOS programs: Prepare your
primary hard disk for TRSDOS-lliTRSDOS programs (Chapter 5) .
Customers with both TRS-XENIX programs and
TRSDOS-II/TRSDOS
programs:
most
TRS-XEN
IX
programs will
run
only under hard disk control, whereas TRSDOS-lliTRSDOS
programs will run under both hard disk control and floppy diskette
control (Exceptions are a few hard disk TRSDOS-II programs that
will
run
only under hard disk control.)
We
recommend you prepare your primary hard disk for TRS-XENIX
programs (Chapter 4). Then,
run
your TRSDOS-IIITRSDDS
programs under floppy diskette Control (Chapter
7)
To Next Page
Loading...
