9
Attention:
(1) Do not click CONNECT before you upload the new firmware, please click DISCONNECT if you
have connected successful before. Upload new firmware will be not success if you have
connected already.
(2) Please do not upload new firmware by wireless data transmission because it has missed the
reset signal.
(3) If there’s without firmware version number, it means failed upload new firmware. It may
cause of network problem, please re-upgrade firmware until shows the version.
Click “Yes” to install the firmware,
Disconnect the USB cable, click OK and then reconnect USB cable immediately (Pay attention:
Mini Pix will have failed to connect if there are more than one COM, please remove other
equipment if disconnect).
Red status LED means the MINI PIX is loading the firmware.
To Next Page
Loading...
Need help?
General
