8
When the gyro is enabled, pull the throttle trigger and then release (make sure the car stops
running), turn the car right or left without changing steering wheel, if the servo will not follow
with, it shows gyro is set backward. Press the binding switch one time for less than 1 second, the
LED flashes red once; gyro is changed to act forward.
(4)
Gyro reverse
Set the gyro forward, turn the car right or left to see whether gyro functions. The wheel will turn left
when the car is turned right and the wheel turns right when the car is turned left. If the gyro acts
counter, press the binding switch two times, the LED flashes two times red, the gyro reverse is
corrected.
Installment of receiver antenna：
(1)
The antenna must be kept as straight as possible. Otherwise it will reduce the effective
range.
(2)
Large model aircraft may of some metal part interfering signal; in this case the antennas
should be placed at both sides of the model. Then the best RF signal condition is obtained at any
flying attitude.
(3)
The antennas must be kept away from conductive materials, such as metal and carbon by at
least a half inch. The coaxial part of the antennas does not need to follow these guidelines, but do not
bend it in a small radius.
(4)
Keep the antennas away from the motor, ESC, and other noise sources as much as possible.
(5)
Press and hold the Easy Link (ID SET) one second, now the receiver starts work.
(6)
After all of the above steps finished, the LED indicator will turn and keep in red/green.
(7)
The receiver can be packed by sponge or foam for shocking proof when it is installed to the
model.
After all of the above steps finished, turn off the transmitter and then power it on, now the program
functions to assure it under control of transmitter with a right connection.
To Next Page
Loading...
Need help?
General
