Radiolink Electronic Ltd
www.radiolink.com
3.3.4.4 RESET
This function is to restore the factory setting when necessary. When press this button, T8FB will make three
slow D sounds, meaning default setting is set.
Chapter 4 T8FB Parameters Setup via Computer
4.1 Software Installation and Connection
1) Connect the computer to the T8FB with an android USB data cable
2) Open the parameter setup software in the downloaded file，then power on T8FB
3) Choose Port Number( COM port will be automatically identified when connected), setting baud rate:
115200, 8-1-None(8 data bits, 1 stop bit, no parity check), click OPEN to connect. These parameters are
on the right of the software interface.
4) T8FB will continuously make D sounds, press any of the trimmer buttons to stop the DD sounds.
Note： When click OPEN to connect, the SETTING parts mentioned above will turn grey and can’t be changed
and PARAMETERS of the connected T8FB includes TX-ALARM/STK-MODE/VERSION, at bottom right will be
displayed
To Next Page
Loading...
Need help?
General
