Radiolink Electronic Ltd
www.radiolink.com
Chapter 1 Introduction
As image of T8FB (Mode 2) shown below, there are one two-way switch, one three-way switch, two VR
switches, four trimmer buttons and two joysticks. The Mode can be personalized to 1(throttle on right hand) or 2
(throttle on left hand) or both sticks return to center points with the small accessory packed in the bag.
Factory setting by default: SwB is CH5, VrB is CH6 , SwA is CH7 and VrA is CH8.
Universal JST battery connector supports multiple batteries, including 4pcs AA batteries or 2S/3S/4S LiPo
battery. Default low battery alarm voltage will be automatically set according to the battery used. Or pilots can
personalize the alarm value with the mobile APP or computer software.
Note The phases of the 4 channels can be easily changed by prodding the corresponding phase switches
instead of modifying the parameter data in the software/APP.
1 Earth Pole
2 Null
3 Voltage Input: 7.4-15V
4 Output: PPM
5 Input：RSSI
To Next Page
Loading...
Need help?
General
