Non-Fire Trouble Events
When a trouble event such as an AC failure occurs,
your command center may be programmed to emit
three warble tones, then a pause (repeatedly).
If the system was armed the command center display
shows the number of non-fire trouble (A1 ##
TROUBLES ) and then custom text for each activated
point.
Silencing Non-Fire Trouble Events
Entering a personal passcode with the proper authority
level silences a trouble and disarms the panel if it was
armed. If you wish to clear the scrolling trouble
message from the display, enter COMMAND 4. If you
wish to review these cleared troubles, this can be done
by using COMMAND 40.
Viewing Non-Fire Trouble Events
After you enter your passcode, the text of the activated
points continues to automatically scroll through the
display. Press NEXT to scroll these displays manually
if you wish. Events scroll from oldest to newest. Use
COMMAND 4 to clear these messages from the
display.
To Next Page
Loading...
Need help?
General
