MASTER ARM ?
COMMAND 1
Turn the Entire System On With Delays
Description
Use this function to turn on the entire system, both
perimeter and interior. When you turn the system on,
the display shows how many seconds of exit delay
time you have to exit the protected area. You should
leave before exit delay time expires.
Leaving after exit delay expires causes entry delay to
start. You may also cause an alarm on an interior
device. Enter your personal passcode to disarm the
system.
This function may be used by your cleaning service, a
serviceman, or others to turn on your system when
they leave.
1
Using Master Arm:
1. The display shows disarmed idle text.
2. Press the COMMAND bar. The display shows
SYSTEM COMMAND.
3. Press the 1 key.
Note: If you prefer, you may use the Command Menu
in place of steps 2 and 3 to initiate this function. Press
the MENU key to enter the Command Menu, then
press NEXT repeatedly until you reach the MASTER
ARM ? prompt. Press ENT. MASTER ARM ALL ?
displays. Press ENT.
4. The display shows ARMING for two seconds,
then displays EXIT NOW # (# = exit delay time
remaining). After the exit delay time expires, the
display changes to idle armed text.
5. To disarm your security system, enter your
personal passcode and press ENT.
To Next Page
Loading...
Need help?
General
