Turning the System On (Arming)
Your security system can be turned on (armed) in
many different ways, depending on the arming
command used. Arming Commands are those
commands used to turn the system on. The most basic
arming command is to arm the entire system. The
simplest way to arm your system is to enter your
personal passcode or COMMAND 1.
There are several other arming commands to turn the
system on. These are described later in this guide.
To Turn Your Security System On (Arm):
1. Enter your passcode and press ENT.
2. The command center briefly displays ARMING,
and the exit delay tone begins. After exit delay
time expires, the display changes to idle armed
text.
To Next Page
Loading...
