System Commands & Functions
Below is a summary of the commands covered in this guide. Some of these functions may not be available in your
system. If you attempt to enter a function that’s not available, COMMAND DISABLED appears in the display for a
few moments before the display returns to idle text. If the function is available in the system but your passcode is
not authorized to perform the function, then NOT AUTHORIZED will display on the Command Center.
Press the COMMAND bar and then the one or two digits shown in the table below to perform the function. When
you use a command to perform a function, the displays in the function list below do not appear at your command
center.
Command Function
CMD 1 MASTER ARM
CMD 1 1 MASTER ARM INSTANT
CMD 2 PERIMETER INSTANT
CMD 3 PERIMETER DELAY
CMD 4 SILENCE THE TROUBLE SOUNDER &
CLEAR TROUBLE DISPLAYS
CMD 4 0 VIEW MEMORY
CMD 4 4 WALK TEST
CMD 4 7 RESET SENSORS
CMD 6 WATCH MODE
CMD 7 SPECIAL ALERT
CMD 8 PERIMETER PARTIAL
CMD 9 SPECIAL ALERT
To Next Page
Loading...
