WALK TEST ?
continued
4. The burglary bell sounds for 2 seconds. When the
display panel shows ## PTS TO TEST you can
begin. Test each point by first opening and then
closing the door or window. Check the display
after testing each point. For interior points, walking
past the device once is sufficient. If any point does
not test correctly, contact your security company
for service.
5. During the Walk Test you may want to see the
points that remain untested. When point text is
displayed, press ESC. The display shows ## PTS
TO TEST. Press the ESC key. VIEW UNTESTED
? is displayed. Press ENT. The display shows ##
PTS UNTESTED. Press NEXT to see a list of the
points that have not yet been tested. Move through
this list by pressing the NEXT key. To resume the
Walk Test, press ESC. # PTS UNTESTED is
displayed. Press ESC. ## PTS TO TEST is
displayed. Resume testing points. To end the Walk
Test, press ESC twice.
6. When all points have been tested, 0 PTS TO
TEST is displayed. Press ESC. The display
momentarily shows ALL PTS TESTED before
returning to idle text.
To Next Page
Loading...
