Shall the baby be weighed sitting make sure it keeps the
balance otherwise the baby could fall of the pan.
It is impossible to tare zero or negative values.
When you tare zero or negative values, message <Err3> is
displayed.
11.3. Press to enter tare manually
Press and key combination, tare value edit box is displayed.
Enter tare value, to do it press and keys: - press to select
digit that is to be edited, - press to set digit value, 0 - 9.
Press key to confirm, the scale returns to the weighing mode,
modified tare value with '–' sign is displayed.
You can enter tare value at any time during the weighing operation.
11.4. Dual Range Devices
Switching from weighing with the accuracy of the I weighing range to weighing
with the accuracy of the II weighing range takes place automatically when
Max of the I weighing range gets exceeded. Upon switching to weighing with
the accuracy of the II weighing range, pictogram/marker is displayed in
the top left hand corner. To return to weighing with the accuracy of the
I weighing range:
unload the weighing pan,
when zero and , pictograms are displayed, press key.
II weighing range pictogram/marker gets blank.
11.5. Units
<P9.Unit> parameter group enables change of start and temporary units.
The unit can be changed to some other unit during weighing or during other
modes except for 'Parts counting' and 'Percent weighing’.
To Next Page
Loading...
Need help?
General
