RADWAG C315 Series

27
ALAS
Select to make the last digit always on.
nEur
Select to make the last digit always off.
uuSt
Select to make the last digit on only when the weighing indication is stable.
 Press key to confirm, next go to the home screen.
13. COMMUNICATION
Communication between the scale and the peripheral devices is established
via the following ports: RS232, USB*, Wi-Fi
®
*. To set the ports go to
<P4.Conn> submenu.
*) - conditioned by the scale type.
13.1. RS232 Port
 Enter <P4.Conn / 4.1.rS1> submenu and set respective transmission
parameters:
4.1.1.bAd
Baud rate: 2400, 4800, 9600, 19200, 38400, 57600, 115200 bit/s.
4.1.2.PAr
Parity: nonE – none; EuEn – even; Odd – odd.
 Press key to confirm, next go to the home screen.
13.2. Wi-Fi
®
Module
 Enter <P4.Conn / 4.3.uuF> submenu and set respective transmission
parameters:
4.3.1.Act
Wi-Fi
®
module activation: YES – module enabled, no – module disabled.
4.3.2.StS
Network connection status: UUAIt – connecting in progress, Connec -
connected, OFF – not connected.
4.3.3.tnn
Time delay. Time interval upon passage of which inactive connection with
Wi-Fi
®
module gets deactivated. The parameter value is declared within
0[s] - [60]s range. 0[s] is set by default (time delay inactive).
 Press key to confirm, next go to the home screen.
In order to provide correct Wi-Fi
®
between the computer and
the scale, you must set computer port parameter in your
scale to value <uuF>.