- 99 -
16. ERROR MESSAGES
-Err2- Value beyond zero range
-Err3- Value beyond tare range
-Err8- Taring / Zeroing operation time exceeded
-NULL- Zero value from converter
-FULL- Measurement range exceeded
-LH- Start mass error
17. ADDITIONAL ECQUIPMENT
Anti-vibration table
It is a very stable basis which eliminates all kinds of vibrations and ground shakes.
The inner part of the table holds a marble plate, which is a foundation for balance
positioning.
Rack for under-pan weighing
The rack is used if under pan weighing option has to be applied. Under pan weighing
is necessary if magnetic loads are weighed or during density determination of
substances. Racks are also used for measuring absorptiveness of substances e.g.
foamed polystyrene. The rack is made of mild steel. Rack height is 330mm.
Density determination kit (for solids and liquids)
It is applicable with balance with resolution at least 1 mg. designed for density
determination of solids and liquids. The procedure is fully automatic, i.e. the user
only places samples on kit’s weighing pans.
Additional display
Features: Length of cable between additional display and balance – 1,5m, plastic
casing, with tilting option.
AP2-1 current loop
Current loop module 4-20mA of RADWAG production is intended for conversion of
digital form of weight indication to analogue value. AP2-1 comprises plastic
housing. It is powered with an external 230V/5VDC power adapter. Both, AP2-1
and power adapter are a set. Current circuit is fed through 1,7-meter long 2-wire
cable.
To Next Page
Loading...
