RADWAG WLC/A2 User Manual

36
17. MISCELLANEOUS PARAMETERS
<P7.Othr> is a group of parameters enabling you to adapt the scale
to individual needs.
17.1. Backlight
Parameter allowing you to change display brightness, the brightness can be
changed within 0% - 100% range.
Procedure:
• Enter <P7.Othr / 7.1.bLbt> submenu.
• Press
key, parameter values are displayed successively one by one,
where:
nonE
Backlight off.
10
Display brightness low limit value in [%].
100
Display brightness high limit value in [%].
• Press key to confirm, next go to the home screen.
17.2. 'Beep' Sound
Parameter allowing you to enable/disable sound signal informing the operator
about pressing panel key(s).
Procedure:
• Enter <P7.Othr / 7.2.bEEP> submenu.
• Press
key, parameter values are displayed successively one by one:
no – sound signal disabled, YES - sound signal enabled.
• Press
key to confirm, next go to the home screen.
17.3. Automatic Shutdown
Parameter allowing you to set time interval, in [min], after which the weighing
device shuts down automatically. If the indication is stable during the declared
time interval, the device is shut down automatically.

RADWAG WLC/A2 Specifications

General

Readability	0.01 g
Pan Size	195 x 195 mm
Calibration	External
Display	LCD (backlit)
Communication	RS 232
Power Supply	100 - 240 V AC 50 / 60 Hz
Repeatability	0.01 g
Stabilization Time	3 s
Operating Temperature	+15°C - +30°C