• If option <LASt> is choosen in the scale program displays estimated
unit mass of the last piece (about 3 sekonds) and then goes to
Counting pieces automatically setting the previously displayed
value as valid for the procedure.
• If the <FrEE> option is selected you will see:
• Using and enter the required sample quantity,
where:
- selection of digit position, - setting the digit,
• Confirm the value by pressing
,
• You will see <LoAd> on the display and then:
• If weighing is performed in a container put the container on the pan
first and then tare it. Then put the declared quantity of pieces on the
pan and confirm it when stable (signalled by
):
• The program will automatically calculate the mass of a single piece
and go on to the Piece Counting mode (pcs). You will see the
following display:
- 37 -
To Next Page
Loading...
